Telemetry Adapter

The JetCat telemetry adapter connects directly to the ECU data bus.
The output of the telemetry adapter is typically directly connected to the receiver
(Telemetry input of the receiver).
The adapter has two outputs connected in parallel so that another device or sensor can be connected to the 2nd port.

The following values can be transferred depending on the system used:

• Exhaust gas temperature in ° C
• Turbines actual speed in 1/min
• Pump voltage in V
• Voltage of the turbine battery in V
• Current consumption in A. Only for ECU V10.0 or higher
• Battery capacity in mAh (Turbine battery). Only for turbines with generator function (for example P220RXi, P180-NX)
• Turbine state and error codes
• rest fuel in ml / rest fuel in%
• fuel flow in ml/min
• Altitude in meters. Only with ECU V10.0 or higher
• Thrust in N
• Turbines Set speed in 1/min
• Airspeed in km/h
• Speed of second shaft (propeller speed for turboprops or main rotor speed for helicopter engines)

Currently supported telemetry systems

• Multiplex Sensor Bus (MSB v2) (M-Link Telemetry)
• HoTTv4
• Futaba S.Bus (Futaba-sensorenliste.pdf)
• Jeti Telemetry (from KW2/2017, telemetry adapters delivered before KW2/2017 have to receive a free firmware update for the Jeti functionality via our service)

ECU V6 required with firmware starting at 6.42 or higher

ECU V12 required with firmware starting at 12.65 or higher

JetCat- Software Download

http://www.jetcat.de/de/service/downloads